What that produces is “straight teeth set on an angle” – which is not a true screw form, as is required. Its teeth are not radially symmetric to the rotational axis. So here’s the tutorial for making a true helical gear, 2 years late.Ī better way is to use this old patternmaker’s trick to create a true helical gear, inspired by Joseph Horner’s “ Helical Gears: a practical treatise” of 1893. He says: “Mark straight diagonal lines, representing the tooth-points, on a strip of paper, and glue this around the face of the prepared block. The bending of the paper to the curvature of the block will develop the helical form from the straight lines.”. ![]() Create your gear profile - the best is Rainer Hessmer’s Involute Spur Gear Builder, or Doug Roger’s standalone app based on the Hessmer algorithm, GearBakery.Įxtrude over this a cylinder equal to the OD of the gear wheel.Use “UnrollSrf” command on the cylinder to make the “strip of paper”, which will presently be wrapped again around the cylinder.ĭraw onto the “paper strip” the lines of the tooth points at the correct bevel angle. Actually, you only need to draw one of them. Use command “FlowAlongSrf” to wrap the line on the “paper strip” (Rhino calls it the “base surface”), back around the cylinder.Įxecute command “Sweep 2 Rails” – one curve is the axial centreline, the other curve is the tooth-point line you drew. ![]() The cross-section is the gear wheel profile. The tooth profiles should be normal to the helix angle.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |